Formwork Plywood | Plywood & Sheet Products

Category Plywood & Sheet Products

Type Plywood

Variants 5 available

Availability In Stock

Delivery Australia-wide

Variants

5 of 5

EziPly Form Ply F17 2400x1200 12mm Request
2400x1200 17mm Hardfaced Formply F14 Request
EziPly Form Ply F17 1800x1200 17mm Request
EziPly Form Ply F17 2400x1200 17mm Request
EziPly Film Face Ply Non Struct 2440x1220 17mm Request

Frequently asked questions

What is F17 form ply and where is it used?

F17 is a structural plywood grade engineered specifically for concrete formwork, with film-faced surfaces that release cleanly from cured concrete and resist scuffing across multiple pour cycles. The F17 stress grade matches AS/NZS 2269 structural plywood requirements while the form-ply face provides a smooth concrete finish. Birak supplies EziPly Form Ply F17 in 12mm and 17mm thicknesses, in 1800x1200 and 2400x1200 sheet sizes, for civil and commercial pour applications.

How many pour cycles can I expect from Birak's Form Ply?

F17 Form Ply reuse depends on handling, demould technique, cleaning and storage between pours. With careful demould and edge protection, F17 form ply typically delivers multiple high-quality pour cycles before face wear affects concrete finish. Hardfaced Formply F14 in 17mm provides an alternative with a more abrasion-resistant face. The Film Face Ply Non-Structural is suited to non-structural form applications. Birak supplies all three lines so you can match product to pour cycle expectations.

F17 Form Ply vs Hardfaced Formply F14 — which should I choose?

F17 Form Ply is the standard structural form ply for general concrete formwork, with high stiffness and clean concrete finish. Hardfaced Formply F14 (17mm) trades a small amount of stiffness for a more abrasion-resistant face surface, which can extend pour-cycle life on heavily reused panels. Non-structural Film Face Ply suits formwork where the panel is not load-bearing. Birak supplies all three on a single PO so contractors can mix face quality per pour requirement.

Can Birak supply Form Ply alongside formwork LVL?

Yes. Birak supplies Form Ply F17, F14 Hardfaced, Form Spec 11.7 LVL bearers and joists, and LVL Concrete Edge on a single purchase order with consolidated audit-ready procurement paperwork. Most state-bound competitors carry either timber or sheet — Birak's nationwide model means civil and commercial contractors get one supplier, one delivery and one invoice for the entire formwork package, simplifying logistics on tight pour schedules.

Does Form Ply count toward IPP procurement spend?

Yes. Birak is Supply Nation Registered, so every dollar spent on Form Ply F17, F14 Hardfaced and Film Face Ply counts toward your Indigenous Procurement Policy 4% target. Audit-ready procurement documentation is supplied automatically with every invoice. For civil contractors on Commonwealth-funded infrastructure, the formwork sheet package is often a high-volume IPP-eligible spend category — sourcing through Birak materially lifts Indigenous procurement contribution.